Mac-Address-Table Static | Static-Multicast | Blackhole - Planet SGS-6341 Series Command Manual

<aging-time> is the aging-time seconds, range from 10 to 1000000; 0 to disable aging.
Command Mode:
Global Mode.
Default:
Default aging-time is 300 seconds.
Usage Guide:
If no destination address of the packets is same with the address entry in aging-time, the address
entry will get aged. The user had better set the aging-time according to the network condition, it
usually use the default value.
Example:
Set the aging-time to 600 seconds.
Switch(config)#mac-address-table aging-time 600
13.1.3 mac-address-table static | static-multicast |
blackhole
Command:
mac-address-table {static | static-multicast | blackhole} address <mac-addr> vlan <vlan-id>
[interface [ethernet | portchannel] <interface-name>] | [source | destination | both]
no mac-address-table {static | static-multicast | blackhole | dynamic} [address <mac-addr>]
[vlan <vlan-id>] [interface [ethernet | portchannel] <interface-name>]
Function:
Add or modify static address entries, static multicast entries and filter address entries. The no
command deletes the three entries.
Parameter:
static is the static entries; static-multicast is the static multicast entries; blackhole is filter entries,
which is for discarding frames from specific MAC address, it can filter source address, destination
address or the both. When choose the filter entries, blackhole address can't based on port, and not
configure to interface; dynamic is dynamic address entries; <mac-addr> MAC address to be added
or deleted; <interface-name> name of the port transmitting the MAC data packet; <vlan-id> is the
vlan number. source is based on source address filter; destination is based on destination address
filter; both is based on source address and destination address filter, the default is both.
Command Mode:
Admin and Configuration Mode.
Default:
13-87