Interface Tunnel - Planet SGS-6341 Series Command Manual

Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-30-4f-89-44-bc interface Ethernet 1/0/1

19.2.29 interface tunnel

Command:
interface tunnel <tnl-id>
no interface tunnel <tnl-id>
Function:
Create/Delete tunnel.
Parameter:
Parameter <tnl-id> is tunnel No.
Command Mode:
Interface Configuration Mode.
Usage Guide:
This command creates a virtual tunnel interface. Since there is not information such as specific
tunnel mode and tunnel source, show ipv6 tunnel does not show the tunnel, enter tunnel mode
after creating, under that model information such as tunnel source and destination can be specified.
No command is to delete a tunnel.
Example:
Create tunnel 1.
Switch(Config)#interface tunnel 1
19.2.30 show ip interface
Command:
show ip interface [<ifname> | vlan <vlan-id>] brief
Function:
Show the brief information of the configured layer 3 interface.
Parameter:
<ifname> Interface name; <vlan-id> VLAN ID.
Parameter:
<ifname> Interface name; <vlan-id> VLAN ID.
Default:
Show all brief information of the configured layer 3 interface when no parameter is specified.
19-189