Ipv6 Address Configuration - Planet WGSW-52040 Configuration Manual

2. Configure the default gateway
Command
Global Mode
ip default-gateway <A.B.C.D>
no ip default-gateway <A.B.C.D>

26.2.2.2 IPv6 Address Configuration

The configuration Task List of IPv6 is as follows:
1. IPv6 basic configuration
(1) Configure interface IPv6 address
(2) Configure default gateway
2. IPv6 Neighbor Discovery Configuration
(1) Configure DAD neighbor solicitation message number
(2) Configure send neighbor solicitation message interval
(3) Configure static IPv6 neighbor entries
(4) Delete all entries in IPv6 neighbor table
1. IPv6 Basic Configuration
(1) Configure interface IPv6 address
Command
Interface Configuration Mode
ipv6 address
<ipv6-address/prefix-length>
[eui-64]
no ipv6 address
<ipv6-address/prefix-length>
(2) Configure default gateway
Command
Global Mode
Explanation
Configure the default gateway of the
route. The no command cancels the
configuration.
Explanation
Configure IPv6 address, including aggregatable
global unicast addresses, site-local addresses
and link-local addresses. The no ipv6 address
<ipv6-address/prefix-length> command
cancels IPv6 address.
Explanation
26-12