Show Ipv6 Mld Groups - Planet SGS-6341 Series Command Manual

Command:
ipv6 mld version <version_no>
no ipv6 mld version
Function:
Configure the version of the MLD protocol running on the interface; the "no ipv6 mld version"
command restores the manually configured version to the default one.
Parameter:
<version_no> is the version number of the MLD protocol, with a valid range of 1-2.
Default:
2 by default
Command Mode:
Interface Configuration Mode
Usage Guide:
While there is routers still not upgraded to version 2 of MLD protocol on the subnet connected, the
interface should be configured to corresponding version.
Example:
Configure the MLD version to 2.
Swith(config)#interface vlan 1
Swith(config-if-vlan1)#ipv6 mld version 2

45.7.15 show ipv6 mld groups

Command:
show ipv6 mld groups [{<ifname | group_addr>}]
Function:
Display the MLD group information.
Parameter:
<ifname> is the name of the interface. Display the MLD group information. <group_addr> is the
group address. Display the specified group information.
Default:
Do not display
Command Mode:
Admin Mode
Example:
Switch#sh ipv6 mld group
MLD Connected Group Membership
Group Address Interface
45-65
Uptime Expires