Ipv6 Pim Ssm - Planet SGS-6341 Series Command Manual

self-rp-address:
anycast-rp address:
other rp unicast rp address:
other rp unicast rp address:
anycast-rp address:
other rp unicast rp address:
45.5 Commands for PIM-SSM6

45.5.1 ipv6 pim ssm

Command:
ipv6 pim ssm {default|range <access-list-name >}
no ipv6 pim ssm
Function:
Configure the range of pim ssm multicast address. The "no ipv6 pim ssm" command deletes
configured pim ssm multicast group.
Parameter:
default: indicates the default range of pim ssm multicast group is ff3x::/32.
<access-list-number > is the name of applying access-list.
Default:
Do not configure the range of pim ssm group address
Command Mode:
Global Mode
Usage Guide:
1. Only this command is configured, pim ssm can be available.
2. Before configuring this command, make sure ipv6 pim multicasting succeed.
3. Access-list only can use the lists created by ipv6 access-list.
4. Users can execute this command first and then configure the corresponding acl; or delete
corresponding acl in the bondage. After the bondage, only command no ipv6 pim ssm can release
the bondage.
5. If ssm is needed, this command should be configured at the related edge route. For example, the
local switch with igmp(must) and multicast source DR or RP(at least one of the two) configure this
command, the middle switch need only enable PIM-SM.
The configured self-rp-address.
The configured anycast-rp-address.
The configured other
accordance with the above anycast-rp-address.
The configured other
accordance with the above anycast-rp-address.
The configured anycast-rp-address*.
The configured other
accordance with the above anycast-rp-address.
45-46
RP communication addresses
RP communication addresses
RP communication addresses
in
in
in