Ethernet-Oam Remote-Failure; Ethernet-Oam Remote-Loopback - Planet SGS-6341 Series Command Manual

Example:
Set the transmission interval of Information OAMPDU for ethernet 1/0/4 to be 2s.
Switch(Config-If-Ethernet1/0/4)# ethernet-oam period 2

11.22 ethernet-oam remote-failure

Command:
ethernet-oam remote-failure
no ethernet-oam remote-failure
Function:
Enable remote failure indication of OAM, no command disables the function.
Default:
Enable.
Command Mode:
Port mode
Usage Guide:
With remote failure indication is enabled, if critical-event or link fault event is occurred locally, it will
notify the peer by sending Information OAMPDU, log the fault information and send SNMP trap
warning. When the remote failure indication is disabled, although local critical-event or link fault
event is not monitored, failure indication information from the peer is still normally received and
processed.
Example:
Enable remote failure indication of ethernet 1/0/4.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam remote-failure

11.23 ethernet-oam remote-loopback

Command:
ethernet-oam remote-loopback
no ethernet-oam remote-loopback
Function:
Local OAM entity sends remote loopback request to enable the remote end to enter OAM loopback
mode, no command disables remote loopback.
Default:
Disable.
11-35