Set Weight - Planet SGS-6341 Series Command Manual

Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set tag 60
31.28 set vpnv4 next-hop
Command:
set vpnv4 next-hop <ip_addr>
no set vpnv4 next-hop [<ip_addr>]
Function:
Configure the next-hop of BGP VPNv4 routing message. The "no set vpnv4 next-hop
[<ip_addr>]" command deletes the configuration.
Parameter:
<ip_addr> is the next-hop ip address of VPNv4 route shown by dotted decimal notation.
Command Mode:
route-map mode
Usage Guide:
To use this command, one match clause should at first be defined.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#set vpnv4 next-hop 10.1.1.1

31.29 set weight

Command:
set weight <weight_val>
no set weight [<weight_val>]
Function:
Configure the weight value of BGP routing message. The "no set weight [<weight_val>]"
command deletes this configuration.
Parameter:
<weight_val> is weight value, ranging between 0～4294967295
Command Mode:
route-map mode
Usage Guide:
31-129