Rename; Rmdir - Planet SGS-6341 Series Command Manual

Example:
Display the current working directory.
Switch#pwd
flash:/
Switch#

2.8 rename

Command:
ename <source-file-url> <new-filename >
Function:
Rename a designated file on the switch.
Parameters:
<source-file-url>is the source file, in which whether specifying or not its path are both acceptable;
<new-filename>is a filename without specifying its path.
Command Mode:
Admin Mode.
Usage Guide:
When using this command, if the new file name is not used as that of any existing directory or file, the rename
operation can be done, or a prompt will indicate its failure.
Example:
Change the name of file "nos.img" in the current working directory to "nos-6.1.11.0.img".
Switch# rename nos5.img nos-6.1.11.0.img
Rename flash:/nos5.img to flash:/nos-6.1.11.0.img ok！

2.9 rmdir

Command:
rmdir <directory>
Function:
Delete a sub-directory in the designated directory on a certain device .
Parameters:
<directory> is the sub-directory name, a sequence of consecutive characters whose length ranges from 1 to 80.
Command Mode:
Admin Mode.
2-109
SGS-6341 Series Command Guide