Tunnel Mode - Planet SGS-6341 Series Command Manual

There is no IPv4 address of tunnel nexthop.
Usage Guide:
This command is for ISATAP tunnel, other tunnels won't check the configuration of nexthop. Notice:
IPv4 address of ISATAP tunnel nexthop and IPv4 address of tunnel source should be in same
segment.
Example:
Configure tunnel next hop 178.99.156.8.
Switch(Config-if-Tunnel1)#tunnel source 178.99.156.7
Switch(Config-if-Tunnel1)#tunnel nexthop 178.99.156.8
Switch(Config-if-Tunnel1)#tunnel mode ipv6ip isatap

19.2.41 tunnel mode

Command:
tunnel mode [[gre] | ipv6ip [6to4 | isatap]]
no tunnel mode
Function:
Configure Tunnel Mode.
Parameter:
gre is GRE tunnel.
Command Mode:
Tunnel Configuration Mode.
Usage Guide:
In configuring tunnel mode, only specifying ipv6ip indicates configuring tunnel. Ipv6ip 6to4 indicates
it is 6to4 tunnel, ipv6ip isatap indicates it is ISATAP tunnel.
Example:
Configure tunnel mode.
1、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip
2、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip 6to4
3、Switch(Config-if-Tunnel1)#tunnel mode ipv6ip isatap
19-200