Ip Bootp-Client Enable; Ip Dhcp-Client Enable - Planet SGS-6341 Series Command Manual

1.3.4 ip bootp-client enable

Command:
ip bootp-client enable
no ip bootp-client enable
Function:
Enable the switch to be a BootP Client and obtain IP address and gateway address through BootP negotiation; the
"no ip bootp-client enable" command disables the BootP Client function and releases the IP address obtained in
BootP.
Default:
BootP client function is disabled by default.
Command mode:
VLAN Interface Mode
Usage Guide:
Obtaining IP address through BootP, Manual configuration and DHCP are mutually exclusive, enabling any two
methods for obtaining IP address is not allowed. Note: To obtain IP address via BootP, a DHCP server or a BootP
server is required in the network.
Example:
Get IP address through BootP.
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip bootp-client enable
Switch (Config-if-Vlan1)#exit
Switch(config)#
Relative command:
ip address, ip dhcp-client enable

1.3.5 ip dhcp-client enable

Command:
ip dhcp-client enable
no ip dhcp-client enable
Function:
Enables the switch to be a DHCP client and obtain IP address and gateway address through DHCP negotiation; the
"no ip dhcp-client enable" command disables the DHCP client function and releases the IP address obtained in
DHCP. Note: To obtain IP address via DHCP, a DHCP server is required in the network.
Default:
the DHCP client function is disabled by default.
1-81
SGS-6341 Series Command Guide