Operating Rules - HP ProCurve 6200yl Series Access Security Manual

Virus Throttling

Operating Rules

3-8

Operating Rules

■ When configuring or changing the configuration of connection-rate
filters in the switch, execute the clear arp command to reset the
routing table.
Connection-Rate filtering is triggered by inbound IP routed traffic
■
exhibiting high rates of IP connections to new hosts. Inbound
switched traffic with high IP connection rates does not trigger
connection-rate filtering. However, after connection-rate filtering has
been triggered on a port, all traffic (switched or routed) from the
suspect host is subject to the configured connection-rate policy
(notify-only, throttle, or block).
Where the switch is throttling or blocking inbound routed traffic from
■
a host, any outbound routed or switched traffic for that host is still
permitted.
A host blocked by connection-rate filtering remains blocked until
■
explicitly unblocked by one of the following:
The vlan < vid > connection-rate-filter unblock command (page 3-18)
•
• Rebooting the switch
Disabling connection-rate filtering using the no connection-rate-filter
•
command.
• Deleting a VLAN removes blocks on any hosts on that VLAN.
Note that changing a port setting from Block to either Throttle or Notify-
Only, does not unblock a blocked host on any port previously set to block.