Configuring Layer 2 Remote Port Mirroring; Layer 2 Remote Port Mirroring Configuration Task List; Configuring A Remote Source Group (On The Source Device) - HP 6125G Configuration Manual

Configuring Layer 2 remote port mirroring

Layer 2 remote port mirroring configuration task list

Configuring Layer 2 remote port mirroring is to configure remote mirroring groups. To do that, configure
the remote source group on the source device and configure the cooperating remote destination group
on the destination device. If an intermediate device exists, allow the remote probe VLAN to pass through
the intermediate device.
NOTE:
HP recommends you not enable GARP VLAN Registration Protocol (GVRP). If GVRP is enabled, GVRP may
register the remote probe VLAN to unexpected ports, resulting in undesired duplicates. For more
information about GVRP, see
Configure the following on the source device:
Source ports
•
• Remote probe VLAN
The egress port
•
Then, configure the following on the destination device:
Remote probe VLAN
•
Monitor port
•
Complete these tasks to configure Layer 2 remote port mirroring:
Task
Configuring a remote
source group
Configuring a remote
destination group

Configuring a remote source group (on the source device)

Creating a remote source group
Step
1. Enter system view.
2. Create a remote source
group.
Layer 2—LAN Switching Configuration Guide
Creating a remote source group
Configuring source ports for the remote source group
Configuring the egress port for the remote source group
Configuring the remote probe VLAN for the remote source group
Creating a remote destination group
Configuring the monitor port for the remote destination group
Configuring the remote probe VLAN for the remote destination group
Assigning the monitor port to the remote probe VLAN
Command
system-view
mirroring-group group-id remote-source
81
.
Remarks
Required.
Required.
Required.
Required.
Required.
Required.
Required.
Required.
Remarks
N/A
By default, no remote
source group exists on a
device.