Honda V65 Magna-VF1100C 1983 Shop Manual page 73

Place the air chamber over the carburetors aligning
the dowel pins with the carburetor holes.
Attach the air chamber to the carburetors with the
eight screws.
Turn the throttle stop screw to align the No.
throttle valve with the edge of the by-pass hole.
Align each throttle valve with the by-pass hole edge
by turning the synchronization adjusting screws.
Inspect throttle operation as described below:
• Open the throttle slightly by pressing the throttle
linkage. Then release the throttle.
• Make sure that it returns smoothly.
• Make sure that there is no drag when opening
and closing the throttle.
Make sure that choke valve operation is smooth by
moving the choke linkage.
Close the choke valve by turning the choke linkage.
Release the choke linkage and make sure that it
returns smoothly.
FUEL SYSTEM
SCREWS
BY-PASS HOLE
No.1 CARBURETOR THROTTLESTqPSCREW
No.3 ADJUSTING SCREW
4-15