Honda V65 Magna-VF1100C 1983 Shop Manual page 197

Press in a new bearing and make sure it rotates
freely.
Place the bearing holder into a vise with soft jaws.
Install and tighten a new bearing outer race lock
nut to the specified torque value.
TORQUE: 90-110 N·m
(9.0-11.0 kg-m, 65-80 ft-lb)
Torque wrench scale reading:
80-100 N·m (8.0-10.0 kg-m, 58-72 ft-lb)
OUTPUT DRIVEN GEAR
INSTALLATION
NOTE:
When the gear set, driven gear bearing and/
or gear case have been replaced, use a shim
0.30 mm (0.012
in) thick for initial re-
ference.
Place the output driven gear bearing holder into a
press.
Then press in the output driven gear.
Install the 0-ring and correct shim. See page
13-14
for shim selection procedure.
ATTACHMENT 52 x 55 mm
07746-0010400
TRANSMISSION
DRIVER
07749- 0010000
PILOT,
30
mm
07746-0040700
LOCK NUT WRENCH
30/64
mm
07916- MBOOOOO
13-11