Honda V65 Magna-VF1100C 1983 Shop Manual page 211

14. DRIVE TRAIN
SERVICE INFORMATION
TROUBLESHOOTING
FINAL DRIVE REMOVAL
DRIVE SHAFT
FINAL DRIVE GEAR
FINAL DRIVE INSTALLATION
SERVICE INFORMATION
GENERAL
• The final drive gear assembly must be removed together w ith the drive shah.
• Replace all oil seals and 0 -rings whenever the final drive gear assembly is disassembled .
14- 1
14- 2
14-3
14- 3
14- 6
14- 18
• Check tooth contact pattern and gear backlash when the bearing, gear set and/or gear case have been replaced.
SPECIF ICATIONS
'83:
Final gear oil
Gear backlash
Capacity
Recommended oil
Gear assembly preldad
Damper case oil capacity
Damper cam spring free length
After 83:
Final gear oil
Capacity
Recommended oil
Gear backlash
Gear assembly preload
Damper case oil capacity
Damper cam spring free length
TORQUE VALUES
Pinion bearing retainer
Pinion nut
Gear case cover bolt 10 mm
8mm
Final gear case attaching nut
Rear axle nut
Axle pinch bolt
STANDARD
170 cc (5.7 ozs) after disassembly
Hypoid-gear o il API, GL- 5
Above 5° C/41 ° F SAE #90
Below 5° C/ 41 ° F SAE #80
0.08- 0.18 mm (0.003-0.007 in)
0.2-0.3 N-m (2-3 kg-em, 1.7 - 2.6 in-lb)
80 cc (2.7 oz)
65 mm (2.6 in)
STANDARD
150 cc (5.1 oz) after disassembly
Hypoid gear oil: SAE #80
0.08- 0.18 mm (0.003- 0.007 in)
0.2-0.3N·m (2- 3 kg-m, 1.7- 2.6 ft-lb)
80 cc (2. 7 oz)
65 mm (2.6 in)
100- 120 N-m (10- 12 kg-m, 72-87 ft-lb)
100-120 N-m (10- 12 kg -m, 72- 87 ft-lb)
35-45 N-m (3.5- 4.5 kg-m, 25- 33 h -lb)
23- 28 N-m (2.3-2.8 kg-m, 17-20 ft -lb)
45-70 N-m (4.5-7.0 kg-m, 33- 51 ft -lb)
85-105 N·m (8.5-10.5 kg-m, 61 76 ft -lb)
20-30 N·m (2.0- 3.0 kg-m, 14-22 ft·lb)
SERVICE LIMIT
-
-
0.30 mm (0.012 in)
-
-
63 mm (2.5 in)
SERV ICE LI M IT
-
-
0.30 mm (0.012 in)
-
-
-
63 mm (2.5 in)
14-1