Honda V65 Magna-VF1100C 1983 Shop Manual page 162

CYLINDER HEAD/VALVE
Turn the crankshaft until there is maximum cam
chain free play, then install the oil pipes under the
cam chain.
Install the cam chain guide on the oil pipe base
plate.
Tighten the cylinder head 1 0 mm bolts in a criss·
cross pattern in
2-3
steps.
TORQUE: 48-52 N·m (4.8-5.2 kg-m, 35-38 ft-lb)
Tighten the cylinder head 8 mm bolts in a crisscross
pattern in
2-3
steps.
TORQUE:
21-25
N·m
(2.1-2.5
kg-m,
15-18
ft-lb)
Tighten the cam shaft holder 6 mm bolts.
TORQUE:
10-14
N·m
(1.0-1.4
kg-m,
7-10
ft-lb)
Lubricate the cam lobes with oil.
Adjust the valve clearance (page 3·9).
Inspect the cylinder head cover gasket for damage
or deterioration.
NOTE:
Clean the gasket before applying sealant.
Apply sealant of the head cover gasket.
Install the front cylinder head cover and gasket.
Install the rear cylinder head cover base cover, and
gaskets. Be sure that the arrow casting on the rear
head cover faces the front of the engine.
Install the remaining parts in the reverse order of
removal.
10-24
OIL PIPE
ARROW CASTING
HEAD COVER BASE REAR HEAD COVER