Honda V65 Magna-VF1100C 1983 Shop Manual page 306

ASSEMBLY
If the piston boots are hardened or deteriorated.
replace them with new ones. The piston seals must
be replaced with new ones whenever they are
removed. Coat the seals with silicone grease or brake
fluid before assembly.
Install the pistons with the dished ends toward the
pads.
Install the collar boots and collar making sure that
the boots are seated in the collar and caliper grooves
properly.
Install the pad spring and pads.
INSTALLATION
Be sure that the retainer clip is in position on the
caliper bracket.
Inspect the condition of the caliper pivot bolt boot.
Apply silicone grease or brake fluid to the caliper
pivot bolt.
Install the caliper assembly over the brake disc so
that the disc is positioned between the pads.
CAUTION :
I
Be careful not to damage the pads.
Install the caliper pivot bolt and caliper bolt.
Connect the brake hose and tighten the brake hose
bolt.
TORQUE:
'83, '84, '85:
25-35 N·m (2.5-3.5 kg-m, 18-25 ft-lb}
After '85:
37-43
N·m
(3.7-4.3
kg-m,
27-31 ft-lb)
Fill the brake fluid reservoir and bleed the brake
system (page 17-4} .
A0°o
~07.
v-"'1
HYDRAULIC BRAKES
COLLAR
BOOTS
/':.
.~. :.,;r
~~
v
\
PISTON 01 L SEALS
PAD SPRING COLLAR
FRONT
,
RETAINER
CLIP
RETAINER
CALIPER PIVOT BOLT
BRAKE HOSE
BOLT
•
CALIPER
BOLT
BRAKE HOSE BOLT
---~...,..-
PIVOT
BOLT
17-13