Honda V65 Magna-VF1100C 1983 Shop Manual page 67

Force a self-tapping 4 mm screw (H/C
069399,
P
/N 93903-3541 0)
into the drilled plug and
continue turning the screwdriver until the plug
rotates with the screw.
Pull on the screw head with pliers to remove the
plug.
Use compressed air to clean the pilot screw area and
remove metal shavings.
Turn each pilot screw in and carefully count the
number of turns before it seats lightly.
Make a note of this to use as a reference when
reinstalling the pilot screws.
CAUTION
Damage to the pilot screw seat wi/1 occur if
the pilot screw is tightened against the seat.
Remove the pilot screws and inspect them. Replace
them if they are worn or damaged.
INSTALLATION
Install the pilot screws and return them to their
original position as noted during removal.
Perform pilot screw adjustment if new pilot screws
are installed (page
4-16).
NOTE
Do not install new plugs on new pilot
screw holes until after adjustment has been
made.
• If you replace the pilot screw in one car·
buretor, you must replace the pilot screws
in the other carburetors for proper pilot
screw adjustment.
FUEL SYSTEM
PILOT SCREW
4-9