Honda V65 Magna-VF1100C 1983 Shop Manual page 303

HYDRAULIC BRA KES
ASSEMBLY
CAUTION:
------
Replace the master cylinder piston, cylinder,
and spring as a set.
Assemble the master cylinder. Coat all parts with
clean brake fluid before assembly. Install the spring
and primary cup together.
Dip the piston cup in brake fluid before assembly.
CAUTION:
When installing the cups, do not allow the lips
to tum inside out. Be certain the circlip is
seated firmly in the groove.
Install the piston and clip.
Install the boot.
Place the master cylinder on the handlebar and
install the holder and the two mounting bolts.
Align the end of the holder with the punch mark
on the handlebar, and tighten the upper bolt first
then tighten the lower bolt.
TORQUE: 10- 14 N·m (1.0 - 1.4 kg-m , 7- 10 ft-lb)
Install the o il hose with the bolt and its two sealing
washers.
Install the brake lever.
Fill the reservoir to the upper level and bleed the
brake system according to page 17-4.
BRAKE CALIPERS
REMOVAL
Place a clean container under the caliper and d is·
connect the brake hose from the caliper.
CAUT ION:
Avoid spilling brake fluid on painted surfaces.
Remove the caliper bolt and pivot bolt.
Remove the caliper.
17-10
'83, '84 : After '84 :
BRAKE FLUID
BRAKE FLUID DOT
-4
i
~ ~ ~ ~
PISTON
~~::
PISTON
~~b~
~~FRONT BRAKE~
6 LIG HT SWITCH
OIL HOSE BOLT
PUNCH MAR K
BRAKE HOSE
PI VOT BO LT
CALIPER BOLT