Honda V65 Magna-VF1100C 1983 Shop Manual page 193

Place the bearing holder in a press and remove the
bearing.
Press in a new bearing.
Place the bearing holder in a vise with soft jaws
and install and tighten a new outer race lock nut
to the specified torque value.
TORQUE: 90-110 N·m
(9.0-11.0 kg-m, 65-80
ft-lb)
Torque wrench scale reading:
80.:..100 N·m (8.0-10.0 kg·m, 58-73 ft·lb)
Stake the new lock nut.
COUNTERSHAFTINSTALLATION
NOTE:
The countershaft and driven gear must be
replaced as a set if they or the gear case or
the bearing require replacement.
Place the countershaft and countershaft bearing
holder into a press. Press the countershaft into the
bearing.
NOTE:
Place the threaded end of the pilot into the
countershaft.
Place the adjustment shim over the bearing holder.
NOTE:
If the countershaft/driven gear, bearing or
gear case are replaced, a new adjustment shim
must be selected (page 13·15, Backlash
Inspection).
ATTACHMENT,
62
x
68
mm
07746-0010500
TRANSMISSION
DRIVER
077 49- 001 0000
PILOT, 35mm
07746-0040800
LOCK NUT WRENCH,
42/56 mm
07916-MB40000
BEARING HOLDER
13-7