Honda V65 Magna-VF1100C 1983 Shop Manual page 160

CYLINDER HEAD/ VALVE
Front Cylinder Head
NOTE :
Install the rear cylinder head camshafts before
you install the front camshafts.
Lubricate the cylinder head cam bearing surfaces
with molybdenum disulfide grease .
Rotate the crankshaft counterclockwise 90 degrees
(1/4 turn). until the T2-4 mark aligns with the rear
crankcase mating surfaces.
CAUTION:
When turning the crankshaft, make sure the
cam chain doesn't jam at the cam chain
tensioner or at the crankshaft.
Install the Intake and exhaust camshafts and spro·
ckets. through the front cylinder cam chain as
shown.
Turn the camshafts so the camshaft marks face up.
Rotate each front camshaft counterclockwise 45
degrees (1/8 turn) to seat the cam fully in the
cylinder head.
If a valve adjuster keeps the camshaft from seating
fully in the cylinder head, back out the adjuster all
the way.
Install the front cylinder camshaft holders and
bolts, as described for the rear cylinder head.
Do not tighten at this time.
Lock the cam chain tensioner for minimum tension.
10-22
MARKS
INTAKE CAMSHAFT