Honda V65 Magna-VF1100C 1983 Shop Manual page 158

CYLINDER HEAD/VALVE
Install the intake and exhaust camshafts and spro-
ckets through the rear cylinder cam chain as shown.
Turn the camshafts so the camshaft marks face up.
NOTE:
If the front cylinder camshafts were not re-
moved, check that the front camshaft marks
face up. If not, turn the crankshaft clockwise
360 degrees (one turn).
If a valve clearance adjuster keeps the camshaft
from seating fully in the cylinder head, back the
adjuster out all the way.
CAUTION:
If you force a valve open while installing the
camshaft holders, you may damage the
holders or the camshaft bearing surfaces.
Place the camshaft holders in the same locations
noted during removal. The groove in the bottom
of the holder must align with the camshaft locating
ridge.
Install the camshaft holder bolts, but do not tighten
them yet.
10-20
CAMSHAFT HOLDERS