INSTALLATION
Install the dowel pins and 0 -ring and install the
oil pump.
Install
the strainer stay with a new
pin
and
install
the oil pipe.
NOTE:
Make sure the 0-rings are installed on the
strainer stay and oil pipe.
Install
the oil strainer and oil pan.
Place the oil pump driven sprocket into the
drive
chain.
NOTE:
The "IN" mark
on
the driven sprocket should
face the crankcase.
Install
the washer and tighten the bolt.
Install the dowel pins and a new gasket.
Install the right side cover.
Install the water pump assy (page 6-11).
Install
the exhaust pipe.
Fill
the engine with the recommended oil (page
2-1
).
LUBRICATION
0-RING
DRIVEN SPROCKET
2-9