Honda V65 Magna-VF1100C 1983 Shop Manual page 310

BRAKE PEDAL SHAFT
REMOVA L
Unhook the brake light switch spring and remove
the rear brake pedal.
Remove the cotter pin and joint pin, and then
disconnect the pedal shaft from the master cylinder
push rod.
Unhook the brake return spring and remove the
rear brake pedal shaft.
INSTA LLATION
Apply grease to the brake pedal shaft and install it
in the frame.
Hook the brake return spring correctly.
Connect the pedal shaft to the master cylinder push
rod end and install the joint pin. Secure the joint
pin with a new cotter pin.
Install the brake pedal aligning the punch marks on
the shaft and pedal.
Tighten the brake pedal bolt.
TORQUE : 24-30 N·m (2.4- 3.0 kg·m, 17-22 ft·lb)
Hook the brake light switch spring.
HYDRA ULIC BRAKES
REAR BRAKE PEDAL
JOINT PI N COTTER PIN BRAKE LIGHT
SWITCH SPR ING
BRAKE LIGHT
SWITCH SPRING
17-17