Honda V65 Magna-VF1100C 1983 Shop Manual page 222

DRIVE TRAIN
Place the pinion assembly into the gear housing.
Drive the pinion assembly into the gear case until
pinion retainer threads can engage with the case
threads.
Apply gear oil to the 0 -ring and threads on the
pinion retainer. Install the 0-ring guide tool.
Screw in the pinion retainer to press the pm10n
bearing in place, then tighten it to the specified
torque.
TORQUE:
100-120
N-m
(10-12
kg-m,
72-87
ft-lb)
RING GEAR ASSEMBLY
Install the original spacer onto the ring gear.
NOTE:
If the gear set, pinion bearing, ring gear bear-
ing and/or gear case are replaced, install a
2.0
mm thick spacer.
Place a new ring gear bearing on the ring gear shaft.
Place the old bearing on top of it. Then, drive the
new bearing onto the shaft with the old bearing and
attachment. Then remove the old bearing.
14-12
RING GEAR SPACER
RETAINER WRENCH
07910-4630100
•· .. w •.