Remove the starter driven gear and needle bearing
from the starter clutch
.
Inspect the rollers for smooth
operation.
Remove the starter clutch cover by removing
the three
bolts.
Remove the clutch rollers, plungers, and springs.
Check the rollers for excessive
wear.
STARTER DRIVEN GEAR
INSPECTION
Inspect the driven gear for damage or excessive
wear.
Measure the driven gear
O.D.
SERVICE LIMIT: 54.16 mm
(2.
132
in)
CLUTCH DISASSEMBLY
NOTE
:
Do not operate the clutch lever after removing
the clutch
.
To do so will cause difficulty in
reassembling the clutch.
Remove
the snap ring, lifter plate, lifter guide,
release bearing, and lifter
rod.
CLUTCH
STARTER DRIVEN GEAR
NEEDLE BEARING
\
STARTER CLUTCH
SPRING------.....~
I
~
~
g
())~
~(II> ~)-1())
\
I
PLUNG~
STARTER CLUTCH COVER
OLLER
LIFTER GUIDE
RELEASE BEARING
7-13