Honda V65 Magna-VF1100C 1983 Shop Manual page 47

Remove the radiator mounting bolts.
Slide the radiator to the right and suspend it from the
handlebar with a piece of wire.
Remove the ignition coils with their bracket and
remove the insulator cover.
Remove the front and rear cylinder head cover bolts
and both cylinder head covers.
INSPECTION
Remove the alternator cover.
Turn the flywheel clockwise until the "T1-3" mark
aligns with the crankcase mating surfaces in com-
pression stroke.
Make sure that the No. 1 piston is at TDC (Top
Dead Center) on the compression stroke.
Insert the camshaft holder as shown and tighten it.
Check the valve clearance for the No.
1
cylinder
usi ng two feeler gauges for each pair of valves.
VALVE CLEARANCE (IN. EX):
0 .15 mm (0 .006 in)
If adjustment is necessary , loosen the lock nuts and
turn the adjusting screws until there is a slight drag
on both feeler gauges. Both feeler gauges should
remain inserted during adjustment.
RAD IATOR
MAINTENANCE
CYLI NDER HEAD
COVER
07979-MK30000
3-13