Honda V65 Magna-VF1100C 1983 Shop Manual page 309

HYDRAULIC BRAKES
REAR MASTER PISTON 0.0.
INSPECTION
Measure the master piston O.D.
SERVICE LIMIT: 13.945 mm (0.5490 in)
Check the primary cup and secondary cup for
damage before assembly.
ASSEMBLY
CAUTION:
----
Replace the master cylinder piston, cylinder,
and spring as a set.
------------~
Assemble the master cylinder.
Coat all parts with clean brake fluid.
Dip the piston cup in DOT -4 brake fluid before
assembly.
CAUTION:
When installing the cups, do not allow the lips
to tum inside out. Be certain the snap ring
is
seated firmly in the groove.
--------
Install the primary cup and piston.
Install the push rod and snap ring.
ASSEMBLY
Install the master cylinder and tighten the attaching
bolt.
Connect the push rod end and brake pedal shaft
with the joint pin. Secure the joint pin with a new
cotter pin.
Connect the brake hoses to the master cylinder and
tighten the brake hose bolt.
TORQUE:
'83, '84, '85:
25-35
N·m
(2.5-3.5
kg-m,
18-25
ft·lb)
After
'85:
37-43
N·m
(3.7-4.3
kg·m,
27-31
ft-lb)
Install the right foot peg bracket.
Fill the brake fluid reservoir and bleed the rear
brake system (page 17 ·4).
17-16
MASTER CYLINDER BODY
MASTER PISTON
PRIMARY CUP AND SPRING
PUSH ROD