Honda V65 Magna-VF1100C 1983 Shop Manual page 224

DRIVE TRAIN
Clean all sealing material off the mating surface of
the gear case and cover.
NOTE:
Q
ep dust and dirt out of the gear case.
careful not to damage the mating
rfaces.
- - - --'
Apply liquid sealant to the mating surface of the
gear case cover.
GEARTOOTHCONTACTPATTERN
CHECK
Apply a thin coat of Prussian Blue to the pinion
gear teeth for a gear tooth contact pattern check.
Place the wave washer and ring gear into the gear
case.
Apply gear oil to the lip of the
011
seal on the gear
case cover and install the gear case cover.
Tighten the cover bolts in
2-3
steps until the cover
evenly touchs the gear case, then tighten the
8
mm
bolts to the specified torque in a crisscross pattern
in two or more steps.
TORQUE :
23-28
N-m
(2.3-2.8
kg·m,
17-20
ft·lb)
Then tighten the 10 mm bolts.
TORQUE : 40- 50 N·m (4.5-5.0 kg·m, 33-36
ft-lb)
14-14
PRUSSIAN BLUE WAVE WASHER
8 mm BOLTS
10 mm BOLTS