Downloading an SD Card to NVRAM
Follow this procedure to download (save) SP data from an SD card to the NVRAM in the
machine.
If the SD card with the NVRAM data is damaged, or if the connection between the controller
and BICU is defective, the NVRAM data download may fail.
If the download fails, repeat the download procedure.
If the second attempt fails, enter the NVRAM data manually using the SMC print you
created before uploading the NVRAM data. (
1.
Turn off the main power of the copier.
2.
Remove the interface cover 2 (
3.
Insert the SD card with the NVRAM data into the service slot 2.
4.
Turn on the main power of the copier.
5.
Execute SP 5825-1 (NVRAM Data Download) and press the "Execute" key.
6.
Turn off the main power of the copier, and then remove the SD card from the slot 2.
7.
Reassemble the machine.
In order for the NVRAM data to download successfully, the serial number of the file
on the SD card must match the serial number of the machine. If the serial numbers
do not match, the download will fail.
This procedure downloads (saves) the following data to the NVRAM:
Total Count
C/O, P/O Count
SM
above procedure)
x 1).
5-5
Using SP Mode
D115/D116