Do NOT press the "Verify" key.
9.
The firmware update program starts and the message "Loading" is displayed.
The update will begin, and then will take a few minutes to complete. The LCD will
initially display, "Updating...
When the update is completed, the LCD display will change to "Update done" or
"Updated / Power Off On".
10. Check that the message "Update Done" is displayed.
-Confirmation-
1.
Turn the main power switch off and on.
The LCD will display "Please wait..." for about 60 seconds, after which it will return to
the "Program UpDate Menu" screen.
2.
Repeat Steps 1-8 above until all firmware updates are complete.
3.
Turn the main power switch off.
4.
Remove the SD card from the lower slot on the controller by pushing on the card to release
the spring lock.
If an error occurs, the error code is displayed. For a list of information on error codes, see the
following table.
SM
***---------".
5-9
Using SP Mode
D115/D116