Ricoh Aficio MP201SPF Service Manual page 425

Original length exceeded
22-00
the maximum scan length
Memory overflow while
22-01
receiving
Tx or rx job stalled due to
22-02 line disconnection at the
other end
The machine cannot store
22-04
received data in the SAF
No G3 parameter
22-05
confirmation answer
Data read timeout during
23-00
construction
The machine software
resets itself after a fatal
25-00
transmission error
occurred
F0-xx V.34 modem error
F6-xx SG3 modem error
SM Appendix
Divide the original into more than one page.
Check the resolution used for scanning. Lower
the scan resolution if possible.
Add optional page memory.
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an
another fax machine, if the machine's printer is
busy or out of order.
Add an optional SAF memory card or hard
disk.
The job started normally but did not finish
normally; data may or may not have been
received fully.
Restart the machine.
Update the ROM
Replace the FCU.
Defective FCU board or firmware.
Restart the machine.
Replace the FCU.
Update the ROM
Replace the FCU.
Replace the FCU.
Update the SG3 modem ROM.
Replace the SG3 board.
Check for line noise or other line problems.
Try communicating another V.8/V.34 fax.
4-21
Fax Error Codes
D115/D116