Df Image Adjustment - Ricoh Aficio MP201SPF Service Manual

Adjusting Copy Image Area

4.14.3 DF IMAGE ADJUSTMENT

Perform the adjustment procedure in this section only when the ARDF is installed on
the copier.
1. Make a temporary test chart as shown in the above diagram. Use the "A4/8.5 x 11" paper to
make it.
2. Place the temporary test chart on the ARDF.
3. Make a copy.
4. Measure the distance between the side edge of the image area and the side edge of the
paper [A].
(The diagram shows the paper on the copy tray. Note that the paper is output with the face
down.)
5. Adjust the side-to-side registration (S to S/Front Regist: SP6-006-001, S to S/Rear Regist:
SP6-006-004). The image area moves to the rear side of the copier when you specify a
larger value.
6. Measure the distance between the leading of the image area and the leading edge of the
paper [B].
7. Adjust the leading edge registration (Leading Regist: SP6-006-002). The image area
moves to the right side of the copier when you specify a larger value.
8. Measure the distance between the trailing edge of the image area and the trailing edge of
D115/D116 4-66 SM