Ricoh Aficio MP201SPF Service Manual page 518

Dedicated Transmission Parameters
0 1
1 0
1 0
1 0
1 0
1 1
1 1
1 1
1 1
Other settings: Not used
4-7 Not used
Switch 03
No FUNCTION
Inch-mm conversion before tx
Bit 1: 0, Bit 0: 0 = Inch-mm
conversion available
0-1
Bit 1: 0, Bit 0: 1 = Inch only
Bit 1: 1, Bit 0: 0 = Not used
Bit 1: 1, Bit 0: 1 = Disabled
DIS/NSF detection method
Bit 3: 0, Bit 2: 0 = First DIS or
NSF
2-3 Bit 3: 0, Bit 2: 1 = Second DIS
or NSF
Bit 3: 1, Bit 2: 0 = Not used
Bit 3: 1, Bit 2: 1 = Disabled
V.8 protocol
4
0: Off
D115/D116
1 1 16800
0 0 19200
0 1 21600
1 0 24000
1 1 26400
0 0 28800
0 1 31200
1 0 33600
1 1 Disabled
The machine uses inch-based resolutions for
scanning. If "inch only" is selected, the printed
copy may be slightly distorted at the other end if
that machine uses mm-based resolutions.
If the setting is "Disabled", the bit switch setting is
used.
(0, 1): Use this setting if echoes on the line are
interfering with the set-up protocol at the start of
transmission. The machine will then wait for the
second DIS or NSF before sending DCS or NSS.
If the setting is "Disabled", the bit switch setting is
used.
If transmissions to a specific destination always
end at a lower modem rate (14,400 bps or lower),
Do not change the settings.
COMMENTS
5-80 SM Appendix