Ricoh Aficio MP201SPF Service Manual page 451

Printing of the error code on
3 the error report
0: No 1: Yes
4 Not used
Power failure report
5
0: Disabled 1: Enabled
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types
of remote terminal ID when
printing reports
7 0: RTI > CSI > Dial label > Tel.
Number
1: Dial label > Tel. number >
RTI > CSI
SM Appendix
1: Error codes are printed on the error reports.
Do not change this setting.
1: A power failure report will be automatically
printed after the power is switched on if a fax
message disappeared from the memory when the
power was turned off last.
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
5-13
Bit Switches
D115/D116