Ricoh Aficio MP201SPF Service Manual page 490

Bit Switches
Maximum allowable frame
interval during image data
4
reception.
0: 5 s 1: 13 s
5 Not used
Reconstruction time for the first
6 line in receive mode
0: 6 s 1: 12 s
7 Not used
G3 Switch 0B Not used (do not change the settings).
G3 Switch 0C Not used (do not change the settings).
G3 Switch 0D Not used (do not change the settings).
G3 Switch 0E [SP No 1-105-015]
Set CNG send time interval
Some machines on the receiving side may not be able to automatically switch the
3-second CNG interval.
0-7
High order bit
Low order bit
D115/D116
This bit set the maximum interval between EOL
(end-of-line) signals and the maximum interval
between ECM frames from the other end.
Try using a longer setting if error code 0-21 is
frequent.
Do not change the settings.
When the sending terminal is controlled by a
computer, there may be a delay in receiving
page data after the local machine accepts
set-up data and sends CFR. This is outside the
T.30 recommendation. But, if this delay occurs,
set this bit to 1 to give the sending machine
more time to send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line
should come within 5 s of CFR.
Do not change the settings.
3000-2250ms: 3000-50xNms
3000 – 50 x Nms 0F (3000 ms) < N < FF (2250
ms)
00-0E(3000-3700ms: 3000+50xNms
3000 – 50 x Nms 0F (3000 ms) < N < 0F (3700 ms)
5-52 SM Appendix