Installation And Wiring Checklist - Siemens SIMATIC S7-300 Manual

Starting up the FM 354
7.1 Installation and wiring
Installation
You can find information about how to install your module:
information
Wiring information
You can find information about how to wire your module:
Checklist The checklist below will help you check important steps in the installation
and parameterization of the FM 354 positioning module.
Table 7-1

Installation and wiring checklist

Step Check
1 Slots
2 Shielding
3 Limit switches
4 Parameterize
7-2
In Chapter 3 of this manual
Inthe manual S7-300 Programmable Controller, Hardware and Installa-
tion
In Chapter 4 of this manual
In the manual S7-300 Programmable Controller, Hardware and Installa-
tion
Plug the module into one of the suitable slots.
Check the shielding of the FM 354 positioning module:
To ensure proper shielding, the module must be screwed down firmly
on the rail.
The shielding for shielded lines for digital I/O modules must be con-
nected to the shielding terminal element.
The shielding for the setpoint cable should not be grounded on the drive-
unit end.
Check the start/stop limit switches. The limit-switch connections must be
connected to the power section. The start/stop limit switches should not be
connected to the digital inputs.
Make sure the FM 354 positioning module setup is consistent with the para-
meterization. Check in particular that:
The attached encoder matches the machine data.
The wiring of the digital I/O modules matches the machine data.
What to do:
FM 354 Servo Drive Positioning Module
OK