Siemens SIMATIC S7-300 Manual page 231

9.3.16 Additional operating data (job no. 110)
Overview
The following display data are additional operating data:
9.3.17 Parameters/data (job no. 114)
Overview The parameters and data requested for reading with the "modify parameters/
data" function job no. 8 (see Section 9.3.1) can be read.
FM 354 Servo Drive Positioning Module
Override (%)
NC traverse program no.
NC block no.
Callup SR loop no. counter
G90/91 active, see Section 10.1
G60/64 active, see Section 10.1
G43/44 active, see Section 10.1
D No. active, see Section 10.1
Status messages 1 (data type: BOOL):
– Speed limitation to limit value from MD23
– Limitation to
10 V
– Limitation of minimum acceleration or minimum deceleration in ef-
fect
Status messages 2 (data type: BOOL): not in use
Description of Functions
9-55