Siemens SIMATIC S7-300 Manual page 305

Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
General data errors
4 (04) 16 (10) Teach In, block number incorrect
Cause
Effect
Elimina-
tion
4 (04) 17 (11) Teach In, dwell time or subprogram-request in block
Cause
Effect
Elimina-
tion
4 (04) 18 (12) Teach In, no axis stoppage
Cause
Effect
Elimina-
tion
4 (04) 40 (28) Transmit non-relevant data
Cause
Effect
Elimina-
tion
4 (04) 81 (51) Programmable modules communication: unauthorized DB type
82 (52)
Programmable modules communication: Info 1 incorrect
83 (53) Programmable modules communication: Info 2 incorrect
84 (54) Programmable modules communication: unauthorized task
85 (55) Programmable modules communication: data errors
Cause
Effect
Elimina-
tion
4 (04) 120 (78) Measurement system grid deviates
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 354 Servo Drive Positioning Module
Error message,
error analysis and elimination
Error response: "Warning" see Table 11-2
The block number in the program selected is not in place.
Teach In is not executed
Specify correct block number
The block number in the program selected is not in place or incor-
rect block number was selected.
Teach In is not executed
Specify correct block number
Axis is still in motion
Teach In is not executed
Stop axis and repeat task
The data (data blocks) transmitted are unknown to the FM 354
Data not accepted
Correct user program
Incorrect data
Task is not executed
Correct and retransmit
The measurement system in the DBs "NC, SM, TO" does not agree
with MD7.
DB does not become effective and is stored non-retentively
Correct and retransmit
Troubleshooting
Message/
Display
CBS
or
DB DB
CBS
or
DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB
CBS
or
DB
11-25