Wiring the FM 354
4.3
Connecting the drive unit
To connect the
Please note:
connecting cables
Note
Use only shielded twisted pairs for lines. The shielding must be connected
to the metallic or metallized connector jacket on the controller side. To pro-
tect the analog setpoint signal against low-frequency interference, we recom-
mend that you not ground the shielding on the drive-unit side.
The cable set supplied as an accessory offers excellent immunity against
interference.
Fig. 4-3
4-6
Connecting cable
SIEMENS
SIMODRIVE
E/R
VSA
Connecting a SIMODRIVE 611-A drive unit
X2
FM 354
Drive unit,
e.g. SIMODRIVE 611-A
FM 354 Servo Drive Positioning Module