Advertisement
GAMMA instabus
Technical product information
June 2010
Switching actuator, main module N 513/11
3x AC 230/400V, 20AX, C-load, load-check
Location and function of the display and
operating elements
A1
A2
A4
A3
A5
A7
A6
Figure 2. Display and operating elements
A1 Plug for bus connection terminal block
A2 Button for switching between normal mode and ad-
dressing mode for transferring the physical address.
A3 LED for indicating normal mode (LED Off) or address-
ing mode (LED On); it turns off automatically after
transferring the physical address
A4 Jack for connection of a switching actuator sub-
module
A5 LED to indicate the selected device
A6 Pushbutton to toggle between Bus and Direct mode
A7 LED to indicate Direct mode = On
A8 Pushbutton for direct operation of outputs 1...3
A9 LED to indicate whether the corresponding output is
switched on or off.
A10 Without function
A11 Without function
A12 Screw-type terminals of outputs 1...3
Installation and wiring
Mounting / dismounting the device:
see figure 3 and 4
B2
B1
Figure 3. Mounting the device
Technical manual
Update: http://www.siemens.com/gamma
2.4.3.6/4
A10
A11
A9
A8
A12
© Siemens AG 2010
Subject to change without further notice
C1
Figure 4. Dismounting the device
Connecting / disconnecting the bus cable: see figure 5
Figure 5. Connecting / disconnecting the bus cable
Connecting a switching actuator submodule: see figure 6
Snap the switching actuator sub-module on to the rail
and push it to the left against the switching actuator
main module or against the switching actuator sub-
module. Connect both devices using the bridging con-
nector supplied.
A
Figure 6. Connecting a switching actuator sub-module
N 513/11, 6 pages
5WG1 513-1AB11
C2
C3
D
D2.3
D2.1 D2.2
D2
D2
D2.4
B
C
Industry Sector, Building Technologies
Low Voltage Distribution
P.O. Box 10 09 53, D-93009 Regensburg
2
D2.4
5 mm
Siemens AG
Advertisement
