Siemens SIMATIC S7-300 Manual page 314

Troubleshooting
Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl. No.
Traversing program errors Error response: "Warning" see Table 11-2
8 (08) 29 (1D) Incorrect D-NO (>20)
Cause
Effect
Elimina-
tion
8 (08) 30 (1E) Error, subroutine
Cause
Effect
Elimina-
tion
8 (08) 31 (1F) Velocity missing
Cause
Effect
Elimina-
tion
8 (08) 32 (20) Error, callup subroutine
Cause
Effect
Elimina-
tion
8 (08) 33 (21) D function unacceptable
Cause
Effect
Elimina-
tion
8 (08) 34 (22)
Incorrect program length
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
11-34
Error message,
error analysis and elimination
The number for tool offset is greater than 20
Program/block not stored
Correct program, per cause
Subroutine without callup number
Program is not stored
Correct program, per cause
No velocity was programmed
Program/block not stored
Correct program, per cause
Block syntax for callup subroutine is incorrect
Program is not stored
Correct program, per cause
Block syntax for invoking a D function is incorrect
Program is not stored
Correct program, per cause
Maximum block number exceeded
Program is not stored
Correct program, per cause
Message/
Display
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
CBS
or
DB DB
FM 354 Servo Drive Positioning Module