Description Of The Drive Interface; Position Of X2 Connector; Pinout Of The X2 Connector - Siemens SIMATIC S7-300 Manual

Wiring the FM 354
4.2

Description of the drive interface

Connector for the
Power sections with an analog interface ( 10 V) can be connected to the
drive unit
9–pin sub–D X2 connector of the FM 354.
The FM 354 also provides an enable signal.
Connector location
Figure 4-2 shows the installation position and identification of the plug on
the module.
Fig. 4-2
Connector pinout Connector identifier:
Connector type:
Table 4-2
Signal names
SW
BS
RF.1...2
Signal type VO
K
4-4
FM 354

Position of X2 connector

Pinout of the X2 connector

Pin Name
1 SW
2 open
3 open
4 open
5 RF.2
Setpoint 10 V
Reference potential for setpoint
Contact for CL controller enable
Voltage outlet
Switching contact
ANAL. OUT X2
1
6
9
5
X2 ANAL. OUT X2
9-pin sub-D plug connector
type Pin Name
VO 6
7 open
8 open
9 RF.1
K
FM 354 Servo Drive Positioning Module
type
BS VO
K