Getting Started With "Parameterize Fm 354 - Siemens SIMATIC S7-300 Manual

Defining Parameters of the FM 354
Chapter over-
view
5.1
5.2
5.3
5.4
5.5
5.1 Installing "Parameterize FM 354"
Prerequisites
The Windows 95 operating system and appropriate STEP 7 program (V3.1 or
higher) must already be installed on the programming device/PC.
For online operation, the link between the PG and the S7-300 CPU must al-
ready be set up (see Figure 4-1). For distributed use of the FM (under devel-
opment), a link from the programming device/PC to the L2-DP network must
already be set up.
Installation
The entire software (parameterization tool, function blocks and preconfigured
user interface for OPs) is stored on two 3.5–inch diskettes and is installed
complete.
Install the software as follows:
1. Insert diskette 1 in the floppy disk drive of your programming device/PC.
2. In Windows 95, start the interactive routine for installing the software by
3. Select the floppy disk drive and the file Setup.exe in the dialog box, and
4. Follow the instructions displayed by the installation program step by step.
Note
If you chose a directory other than SIEMENS/STEP7 when you installed
STEP 7, this directory is entered instead.
5-2
In Section
Installation of "Parameterize FM 354"

Getting started with "Parameterize FM 354"

Parameterization data
Parameterization with "Parameterize FM 354"
Storing the parameter data in SDB
double–clicking the "Software" symbol in the Control Panel.
start the installation program.
Result: The software is installed in the following directories:
– "Parameterize FM 354" parameterization tool:
SIEMENS\STEP7\S7FLAG
– Function blocks: SIEMENS\STEP7\S7LIBS\FMST_SRV
– User interface for OPs: SIEMENS\STEP7\EXAMPLES\S7OP_BSP
– Example applications: SIEMENS\STEP7\EXAMPLE1\FMSTSVEX
you will find
1 000
FM 354 Servo Drive Positioning Module
on page
5-2
5-3
5-6
5-22
5-26