Overview Display For Parameterization - Siemens SIMATIC S7-300 Manual

Defining Parameters of the FM 354
7. By clicking the tabs in this window (General, Addresses and Basic Pa-
Note:
Further operation of the FM 354 is not possible with the CPU in the STOP
state.
Click the Parameters button to call up the screen for setting the parameters.
Fig. 5-3
You can return to this display at any point during parameterization by select-
ing the menu View Overview.
The FM 354 module for servo–controlled positioning is parameterized by
way of parameter DBs that reside in memory on the module. Here a key
function is performed by the "Machine data" data block (DB-MD), since it
is always needed, regardless of what technological function the module per-
forms. All other parameter DBs are only needed as a function of the technol-
ogy involved.
You can now set the parameters of your module. This chapter gives you an
overview of the parameters that can be set.
You can use the mouse to change the size of the window for entering the pa-
rameter data and the size of the overview display.
5-4
rameters), you can
– Name the FM 354
– Change the address of the FM 354
– Configure the interrupts.

Overview display for parameterization

FM 354 Servo Drive Positioning Module