Siemens SIMATIC S7-300 Manual page 76

Defining Parameters of the FM 354
Table 5-9 Menus of "Parameterize FM 354", continued
Menu title or entry
(with single command)
Destination system
Communications
Load >
in FM
in PG or FM...
Online editing >
Machine data
Increment
Tool offset data
Traversing program
User data
Compress FM-RAM
Clear flash memory
Test
Startup
Troubleshooting
Service data
View
Table form
Contents of column 5
Default value
Limits
Function bar
Status line
Overview
5-24
Shortcut
– Transfers data and data blocks
– Establishes or disconnects online connection with destination system
– Loads data blocks or user data
– Loads the current data block on the FM 354
– Opens a transfer dialog
– Edits the data blocks on the FM 354
– Edits the machine data on the FM 354
– Edits the increments on the FM 354
– Edits the tool offset data on the FM 354
– Edits the traversing programs on the FM 354
– Edits the user data on the FM 354
– Compresses the FM 354 RAM. This is possible only if the CPU is in
STOP mode.
– Clears the FLASH memory on the FM 354
– Startup and troubleshooting
– Opens the startup window.
Module control and observation
– Opens the troubleshooting window.
Displays faults in the module
– Opens the window to look at servicing data
– Select different views and presentations
– Switches between dialog and table format (only with MD)
– Defines what appears in the last column (MD only)
– Displays default values (recommendations)
– Displays upper and lower limits
– Displays the function bar (on/off)
– Displays the status line (on/off)
– The overview display for parameterization appears
Significance
FM 354 Servo Drive Positioning Module