Location Of The X3 Connector - Siemens SIMATIC S7-300 Manual

Procedure to con- Connect the drive unit as follows:
nect the connect-
1. Wire the free cable end of the connecting cable to the terminals of the
ing cable
2. Open the front door and plug the sub-D connector into the module.
3. Lock the connector in place with the knurled screws. Close the front door.
Designation of the
The connecting cable is a prefabricated cable for an axis with an analog in-
connecting cable
terface, terminal designation for SIMODRIVE drive units.
Order No.:
The connecting cable is available in a variety of lengths.
see
4.4 Description of the measurement system interface
Connectors for A 15–pin female sub D connector is provided for the connection of incremen-
encoders tal encoders or absolute encoders (serial port).
Location of con- Figure 4-4 shows where the connector is installed on the module, and how it
nector
is identified.
Fig. 4-4
FM 354 Servo Drive Positioning Module
drive unit. (The terminal identifiers on the cable ends indicate the proper
terminals for SIMODRIVE units.)
6FX2 002-3AB01-0
Order No.: E86060-K4490-A001-A4.
FM 354

Location of the X3 connector

Wiring the FM 354
0
ENCODER X3
15 8
9
1
4-7