Siemens SIMATIC S7-300 Manual page 297

Table 11-6 Operator control errors, continued
Cl. No.
Operator control errors
2 (02) 12 (0C) Axis movement not possible
Cause
Effect
Elimina-
tion
2 (02) 13 (0D) Incremental value not in place
Cause
Effect
Elimina-
tion
2 (02) 14 (0E) No program preselected
Cause
Effect
Elimina-
tion
2 (02) 15 (0F) Digital input not activated
Cause
Effect
Elimina-
tion
2 (02) 16 (10) Measurement function undefined
Cause
Effect
Elimina-
tion
2 (02) 21 (15) Activate machine data not allowed
Cause
Effect
Elimina-
tion
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
FM 354 Servo Drive Positioning Module
Error message,
error analysis and elimination
Error response : "Feed STOP" see Table 11-2
With an unacknowledged error, no drive enable or stop, a traverse
command was triggered.
Restore traverse command and switch acknowledge error or Stop to
inactive, or give drive enable.
The setpoints defined by the operating mode parameters are mis-
sing or a change in incremental dimensions occurred when the op-
erating mode started.
Parameterize and read in setpoint parameters
No program preselected at "Start."
First preselect program then start.
The programmed target was reached in a block with external block
change (G50).
Check programming (MD34) and connection of digital input.
Length measurement and inprocess measurement selected simulta-
neously
No measurement function effective.
Reselect one of the two measurement functions.
"Processing in progress" is still active
Activate machine data not executed
Terminate processing, repeat activation
Troubleshooting
Message/
Display
CBS
CBS
CBS
CBS
CBS
CBS
11-17