Siemens SIMATIC S7-300 Manual page 328

Index
reference point coordinates, 7-22
reference point offset, 9-67
reference point switch, 7-22, 9-18
switch alignment, 7-22, 9-54
reference point switch , 9-67
reference-point coordinate, 7-25
removing the FM 354, 3-3
restart, 9-43
retrigger reference point, 9-39
reversing switch, 9-19
rotary axis, 9-25, 9-45, 9-57
rotary axis end, 9-58
S
safety rules, 4-1
EMERGENCY OFF devices, 4-1
service data, 7-9
servicing data, 9-54
servo enable, 9-41, 9-71
servo ready, 9-72
Set actual value, 9-17, 9-43
undo set actual value, 9-43
set actual value, 9-46
set actual value on–the–fly, 9-47
set actual value on-the-fly, 10-5
set actual value on–the–fly, 9-47
Set actual value on-the-fly, 9-8
set actual value on-the-fly, 10-5
Set reference point, 7-23, 7-25
set reference point, 9-49
SIMATIC Manager, 5-3
simulation, 9-41
single commands, 9-42
activate machine data, 9-42
automatic block search forward/backward,
9-31
delete residual path, 9-43
restart, 9-43
undo set actual value, 9-43
Index-4
single functions, 9-39
deactivate automatic drift compensation,
9-41
deactivate software-end position monitoring,
9-40
follow–up mode, 9-40
inprocess measurement, 9-39
length measurement, 9-39
parking axis, 9-41
retrigger reference point, 9-39
servo enable, 9-41
simulation, 9-41
switch off enable input, 9-40
slots for the FM 354, 3-1
software limit switches, 7-25, 9-82
start enable, 9-6
Startup, 7-6
switch off enable input, 9-40
synchronization, 9-17, 9-67, 9-68
absolute encoder alignment, 9-67
measured value synchronization, 9-68
reference point, 9-67
reference point approach, 9-67
reference point offset, 9-67
reference point switch, 9-67
synchronization point, 9-67
system data, 9-35
change parameters/data, 9-36
diagnostic interrupt data, 6-19
measured values, 9-50
set actual value, 9-46
set actual value on–the–fly, 9-47
set reference point, 9-49
single commands, 9-42
single functions, 9-39
zero offset, 9-44
system data block, 5-7, 5-26
system of measurement, 9-56
system overview, 1-5
components, 1-5
data handling, 1-7
T
Teach in, 9-49
testing (machine axis), 7-6
time override, 9-5
tool compensation, 10-10
tool offset data, 5-18
traversing block, 9-25
FM 354 Servo Drive Positioning Module