Chrysler Sebring 2004 Service Manual page 1657

23 - 130 SUNROOF
SUNROOF HOUSING DRAIN HOSE (Continued)
REAR HOUSING HOSE
(1) Connect the drain hose to the sunroof housing
and test drainage (Fig. 5).
(2) Set headliner into position.
(3) Connect express module, drive motor, and con-
trol switch wire connectors.
(4) Test sunroof operation, adjust as necessary.
(5) Finish installing headliner. (Refer to 23 -
BODY/INTERIOR/HEADLINER - INSTALLATION).
(6) Install sunroof opening trim lace. (Refer to 23 -
BODY/SUNROOF/OPENING TRIM LACE - INSTAL-
LATION).
(7) Connect the control switch wire connector.
Install control switch.
SUNROOF MODULE
ASSEMBLY
REMOVAL
(1) Move glass panel to the fully closed position.
(2) Disconnect battery negative cable.
(3) Recline both front seats.
(4) Remove sunroof opening trim lace. (Refer to 23
- BODY/SUNROOF/OPENING
REMOVAL).
(5) Remove control switch. (Refer to 23 - BODY/
SUNROOF/CONTROL SWITCH).
(6) Disconnect wire harness.
(7) Remove headliner
(8) Disconnect the drain tubes from sunroof hous-
ing.
(9) Loosen fasteners attaching sunroof module
assembly (Fig. 6).
(10) With the aid of a helper, remove fasteners
attaching sunroof module assembly to roof panel.
Fig. 6 Sunroof Module Assembly
1 - (6) SCREWS
INSTALLATION
NOTE: There are locating pins on the roof panel
near the front corners of the sunroof opening that
will help position the sunroof module correctly.
tion.
guide into position and start fasteners.
ule to roof panel. Tighten the fasteners to 11 N·m (97
in. lbs.) torque.
trol switch wire connectors.
-
INSTALLATION).
TRIM LACE -
OPENING TRIM LACE
REMOVAL
end of the lace away from the headliner until the
entire lace is removed (Fig. 7).
INSTALLATION
joint, fully seat the lace in place around the sunroof
opening. Cut to fit if necessary.
(1) With the Glass panel in the fully closed posi-
(2) Raise rear end of sunroof module assembly and
(3) Tighten the fasteners holding the sunroof mod-
(4) Connect the drain tubes to the sunroof housing.
(5) Connect wire harness.
(6) Set headliner into position.
(7) Connect battery negative cable.
(8) Connect express module, drive motor, and con-
(9) Test sunroof operation, adjust as necessary.
(10) Finish installing the headliner.
(11) Install sunroof opening trim lace. (Refer to 23
BODY/SUNROOF/OPENING
Remove lace by starting at the joint and pull one
Fig. 7 Sunroof Opening Trim Lace
1 - OPENING TRIM LACE
Install lace by starting at the spot of the previous
JR
TRIM LACE -